Schoeps MK 2 Omni Capsule
This capsule type has a flat frequency response for frontal sound incidence. This yields a very natural sound when recordings are made within the reverberation radius, where the direct sound (frontal incidence) predominates over the reverberant sound (random angles of incidence).
- Omnidirectional pattern
- Very flat frequency response
- Corrected for a free sound field
- For use close to the sound source (frontal sound
- Often preferred for relatively close miking of instruments, vocalists, etc.
The capsules of condenser microphones (the only type which Schoeps manufactures) can't be connected directly to microphone cables or inputs; a microphone amplifier is required in between. Thus a complete microphone of the Colette series comprises any of the twenty available types of capsules combined with an amplifier.
The Schoeps CMC 6 Amplifier is designed for standard 48- and 12-Volt phantom powering. Its circuitry recognizes the supply voltage and adjusts itself automatically. Its performance characteristics remain essentially the same either way; mainly, the difference is that the current drawn at 12 Volts is greater than at 48 Volts. However, the 12-Volt mode consumes less power and might be preferred for battery-powered recording.
- Flat frequency response
- Extremely low noise and distortion
- Balanced, very low-impedance output
- Can be used with very long cables
- Well-protected against RFI
- For use with 12- or 48-Volt phantom powering
The microphone amplifier provides the electrostatic charge which the capsule requires in order to produce a signal. Since only a minuscule amount of current is contained in this signal, amplification of the current is required. To avoid interference to the signal on the way from the microphone to the input of the mixer or preamp, the signal is conveyed at low impedance and in balanced form. The CMC 6 amplifier offers a symmetrical, transformerless, direct-coupled Class A output stage with low impedance, low distortion, and high freedom from interference.
The two amplifiers in a stereo pair of microphones should be of the same type. On request, Schoeps can select ”matched pairs” of capsules with equal sensitivity and frequency response for critical applications, at slight additional cost.