Furman PL-PLUS CE – No Longer Available
SMP+ (Series Multi-Stage Protection Plus)
Furman’s SMP+ surge suppression virtually eliminates service calls. Traditional surge suppression circuits “sacrifice” themselves when exposed to multiple transient voltage spikes, requiring the dismantling of your system, and repair of your surge suppressor. Not so with SMP+. With Furman’s SMP+, damaging transient voltages are safely absorbed, clamped and dissipated. No sacrificed parts, no service calls, no down time.
Unique to Furman’s SMP+ is its unparalleled clamping voltage (even when tested beyond the grueling specifications of - USA/CIDA’s A-1-1 test). While other designs offer clamping voltages that are well above 300VAC peak, (far beyond long accepted professional standards), Furman’s SMP+ clamps at 188VAC peak, 133 VAC RMS even when tested with multiple 6000VAC - 3000 Amp surges! This unprecedented level of protection is only available with Furman’s SMP+ technology. Additionally, Furman’s trusted over-voltage circuitry protects against all too frequent accidental connections to 208 or 240VAC, by shutting off the incoming power until the over voltage condition is corrected.
LiFT (Linear Filtering Technology)
Unfortunately, traditional AC filter - Conditioners have been designed for unrealistic laboratory conditions. Prior technologies could actually harm audio and video performance more than they help, due to the resonant peaking of their antiquated, non-linear designs. Under certain conditions, these designs can actually add more than 10 dB of noise to the incoming AC line! Worse still, lost digital data, the need to re-boot digital pre-sets, or destroyed digital converters are frequently caused by excessive voltage spikes and AC noise contaminating the equipment ground. Furman’s SMP+ with LiFT takes another approach, ensuring optimal performance through linear filtering and no leakage to ground.
Models PL-8 II E, PL-PLUS II E, PL-PLUS DE II, and PM-8E II: “E” suffi x versions are for use in countries with 220/240 volt AC lines. Each has ten rear panel outlets, using internationally- accepted IEC-320 connectors. The voltmeter on the PL-PLUS E II reads from 180 to 256 VAC, in 4 volt steps.
- SMP+ provides the highest level of protection available
- LiFT significantly reduces AC line noise
- E.V.S. protects equipment from dangerous overvoltage conditions
- Zero ground contamination circuitry assures delivery of pure AC
- Two retractable, long-life, low-heat LED lights with dimmer for rack illumination
- BNC connector on the rear panel allows connection of any standard gooseneck lamp
- Front panel meter displays incoming line voltage ranging from 90 to 128 volts
- Eight rear panel outlets and one front panel outlet
- 15 amp rating, with circuit breaker
- Three year limited warranty
When it comes to getting the best gear, your tastes are probably pretty particular. Vintage King can help answer any and every question to help you make the right decisions for your sound. Fill out the form below and we'll be in contact with you shortly.
Free shipping to the lower 48 US states on orders $99 and up. See details.
* Required Fields
Please fill out the form below and, when Furman PL-PLUS CE becomes available, a Vintage King Audio Consultant will contact you.